Theophylline Sodium Glycinate Tablets
» Theophylline Sodium Glycinate Tablets contain an amount of theophylline sodium glycinate equivalent to not less than 93.0 percent and not more than 107.0 percent of the labeled amount of anhydrous theophylline (C7H8N4O2).
Packaging and storage— Preserve in well-closed containers.
Labeling— Label the Tablets to state both the content of theophylline sodium glycinate and the content of anhydrous theophylline.
USP Reference standards 11
USP Theophylline RS Click to View Structure
Identification— Triturate a quantity of finely powdered Tablets, equivalent to about 500 mg of theophylline, with 10-mL and 15-mL portions of solvent hexane, and discard the solvent hexane. Triturate the residue with two 10-mL portions of a mixture of equal volumes of 6 N ammonium hydroxide and water, and filter each time. Evaporate the combined filtrates to about 5 mL, neutralize, if necessary, with 6 N acetic acid, using litmus, and cool to about 15, with stirring. Collect the precipitate on a filter, wash it with cold water, and dry at 105 for 1 hour: the theophylline so obtained melts between 270 and 274, the procedure for Class I being used (see Melting Range or Temperature 741), and responds to Identification test B under Theophylline Sodium Glycinate.
Dissolution 711
Medium: water; 900 mL.
Apparatus 1: 100 rpm.
Time: 45 minutes.
Procedure— Determine the amount of anhydrous theophylline (C7H8N4O2) dissolved from UV absorbances at the wavelength of maximum absorbance at about 272 nm of filtered portions of the solution under test, suitably diluted with Dissolution Medium, if necessary, in comparison with a Standard solution having a known concentration of USP Theophylline RS in the same medium.
Tolerances— Not less than 75% (Q) of the labeled amount of anhydrous C7H8N4O2 is dissolved in 45 minutes.
Uniformity of dosage units 905: meet the requirements.
Assay— Place 20 Tablets in a 200-mL volumetric flask, add 50 mL of water, and when the tablets have disintegrated add 50 mL of 6 N ammonium hydroxide. Shake until no more dissolves, then dilute with water to volume, mix, and filter through a dry filter into a dry flask, discarding the first 20 mL of the filtrate. Transfer an accurately measured aliquot of the subsequent filtrate, equivalent to about 250 mg of theophylline, to a 250-mL conical flask, add 20.0 mL of 0.1 N silver nitrate VS, and heat on a steam bath for 15 minutes. Filter through a filter crucible under reduced pressure, and wash the precipitate with three 10-mL portions of water. Acidify the combined filtrate and washings with nitric acid, and add an excess of 3 mL of the acid. Cool, add 2 mL of ferric ammonium sulfate TS, and titrate the excess silver nitrate with 0.1 N ammonium thiocyanate VS. Each mL of 0.1 N silver nitrate is equivalent to 18.02 mg of C7H8N4O2.
Auxiliary Information— Please check for your question in the FAQs before contacting USP.
Topic/Question Contact Expert Committee
Monograph Mary S. Waddell
Scientific Liaison
1-301-816-8124
(SM42010) Monographs - Small Molecules 4
Reference Standards RS Technical Services
1-301-816-8129
rstech@usp.org
711 Margareth R.C. Marques, Ph.D.
Senior Scientific Liaison
1-301-816-8106
(GCDF2010) General Chapters - Dosage Forms
USP35–NF30 Page 4832