|
Chromic Phosphate P 32 Suspension
» Chromic Phosphate P 32 Suspension is a sterile, aqueous suspension of radioactive chromic phosphate P 32 in a 30 percent Dextrose solution suitable for intraperitoneal, intrapleural, or interstitial administration. It contains not less than 90.0 percent and not more than 110.0 percent of the labeled amount of 32P as chromic phosphate expressed in megabecquerels (millicuries) per mL at the time indicated in the labeling. It may contain a preservative or a stabilizer. Other chemical forms of radioactivity do not exceed 5.0 percent of the total radioactivity.
Packaging and storage
Preserve in single-dose or multiple-dose containers.
Labeling
Label it to include the following, in addition to the information specified for Labeling under Injections
USP Reference standards
USP Endotoxin RS
Radionuclide identification
A:
The beta radiation of the Suspension, measured according to the procedure set forth under Radioactivity
B:
Its beta-ray spectrum is identical to that of a specimen of 32P of known purity showing no distinct photopeaks and no energies greater than 1.710 MeV.
Bacterial endotoxins
pH
Radiochemical purity
Place a measured volume of Suspension, to provide a count rate of about 20,000 counts per minute, about 2.5 cm from one end of a 25-mm × 300-mm strip of chromatographic paper (see Chromatography
Other requirements
It meets the requirements under Injections
Assay for dextrose
Periodic acid reagent solution
Dissolve 8.5 g of sodium metaperiodate in 80 mL of 1 N sulfuric acid, dilute with water to 100 mL, and mix.
Assay preparation
Decant the supernatant from sterile Suspension into a disposable centrifuge tube, and centrifuge. Pipet 1.0 mL of the clear supernatant into a 25-mL volumetric flask, dilute with water to volume, and mix.
Procedure
Pipet 50 mL of Periodic acid reagent solution into a 250-mL conical flask, add 3.0 mL of the Assay preparation, swirl, cover the flask, and allow to stand at room temperature for 2 hours. Add, in the order named and with rapid stirring, 50 mL of a saturated solution of sodium bicarbonate, 50.0 mL of 0.1 N potassium arsenite VS, 4 mL of potassium iodide solution (1 in 5), and 20 g of sodium bicarbonate. Stir the solution at room temperature for 15 minutes. Titrate with 0.1 N iodine VS, using 3 mL of starch TS as the indicator. Perform a blank determination, and make any necessary correction. Each mL of 0.1 N iodine is equivalent to 1.802 mg of dextrose (C6H12O6). Not less than 27.0% and not more than 33.0% is found.
Assay for radioactivity
Using a suitable counting assembly (see Assay, Beta-emitting under Radioactivity
Auxiliary Information
Please check for your question in the FAQs before contacting USP.
USP35NF30 Page 4315
Pharmacopeial Forum: Volume No. 27(6) Page 3323
|