Morphinan-6-one, 4,5-epoxy-3-methoxy-17-methyl-, (5)-, [R-(R*,R*)]-2,3-dihydroxybutanedioate (1:1), hydrate (2:5).
4,5-Epoxy-3-methoxy-17-methylmorphinan-6-one tartrate (1:1) hydrate (2:5) [34195-34-1; 6190-38-1].
Anhydrous 449.46 [143-71-5].
» Hydrocodone Bitartrate, dried in vacuum at 105 for 2 hours, contains not less than 98.0 percent and not more than 102.0 percent of C18H21NO3·C4H6O6.
Packaging and storage Preserve in tight, light-resistant containers.
USP Reference standards 11
USP Dihydrocodeine Bitartrate RS.
USP Hydrocodone Bitartrate RS.
USP Hydrocodone Bitartrate Related Compound A RS .
B: Ultraviolet Absorption 197U
Solution: 100 µg per mL.
Medium: 0.1 N sulfuric acid.
Specific rotation 781S: between 79 and 84.
Test solution: 20 mg, undried, per mL, in water. Calculate the result on the basis of the undried aliquot.
pH 791: between 3.2 and 3.8, in a solution (1 in 50).
Loss on drying Dry it in vacuum at 105 for 2 hours [noteSee the Note in the Assay for precautions regarding handling of the dried material.]: it loses not less than 7.5% and not more than 12.0% of its weight.
Residue on ignition 281: not more than 0.1%.
Chloride To 10 mL of a solution (1 in 100), acidified with nitric acid, add a few drops of silver nitrate TS: no opalescence is produced immediately.
Assay [noteDry both the USP Hydrocodone Bitartrate RS and the Hydrocodone Bitartrate materials in vacuum at 105 for 2 hours. Immediately transfer the dried materials to a desiccator containing phosphorus pentoxide. Weigh each dried material individually within 1 minute, and proceed with the Assay.]
Mobile phase Prepare a mixture of acetonitrile, water, and diethylamine (800:4:1). Prepare a filtered and degassed mixture of this solution and methanol (55:45). Make adjustments if necessary (see System Suitability under Chromatography 621).
Standard preparation Transfer about 10 mg of previously dried USP Hydrocodone Bitartrate RS, accurately weighed, to a 10-mL volumetric flask, add 5 mL of water, and mix to dissolve. Dilute with methanol to volume, and mix to obtain a solution having a known concentration of about 1 mg per mL.
Assay preparation Transfer an accurately weighed quantity of previously dried Hydrocodone Bitartrate, equivalent to about 100 mg of hydrocodone bitartrate, C18H21NO3·C4H6O6, to a 100-mL volumetric flask, add 50 mL of water, and mix to dissolve. Dilute with methanol to volume, and mix.
Resolution solution Prepare a solution in methanol containing about 0.4 mg of USP Dihydrocodeine Bitartrate RS and 0.6 mg of USP Hydrocodone Bitartrate RS per mL. Prepare a mixture of this solution and water (1:1).
Chromatographic system (see Chromatography 621) The liquid chromatograph is equipped with a 280-nm detector and a 4.6-mm × 25-cm column that contains packing L3. The flow rate is about 1.5 mL per minute. Chromatograph the Resolution solution, and record the responses as directed for Procedure: the relative retention times are about 0.7 for hydrocodone and 1.0 for dihydrocodeine; and the resolution, R, between hydrocodone and dihydrocodeine is not less than 3.0. Chromatograph the Standard preparation, and record the peak responses as directed for Procedure: the relative standard deviation for replicate injections is not more than 1.0%.
Procedure Separately inject equal volumes (about 20 µL) of the Standard preparation and the Assay preparation into the chromatograph, record the chromatograms, and measure the responses for the major peaks. Calculate the quantity, in mg, of C18H21NO3·C4H6O6 in the portion of Hydrocodone Bitartrate taken by the formula:
(100C)(rU / rS)in which C is the concentration, in mg per mL, of USP Hydrocodone Bitartrate RS in the Standard preparation; and rU and rS are the peak responses obtained from the Assay preparation and the Standard preparation, respectively.
Auxiliary Information Please check for your question in the FAQs before contacting USP.Chromatographic Column
USP32NF27 Page 2568Pharmacopeial Forum: Volume No. 30(5) Page 1628
Chromatographic columns text is not derived from, and not part of, USP 32 or NF 27.