Flurazepam Hydrochloride Capsules
» Flurazepam Hydrochloride Capsules contain not less than 90.0 percent and not more than 110.0 percent of the labeled amount of flurazepam hydrochloride (C21H23ClFN3O·2HCl).
Packaging and storage Preserve in tight, light-resistant containers.
A: Dissolve a portion of Capsules, equivalent to about 30 mg of flurazepam hydrochloride, in 10 mL of methanol, filter, and proceed as directed for Identification test C under Flurazepam Hydrochloride.
B: The retention time of the major peak for flurazepam hydrochloride in the chromatogram of the Assay preparation corresponds to that in the chromatogram of the Standard preparation, as obtained in the Assay.
C: Capsules meet the requirements under IdentificationOrganic Nitrogenous Bases 181.
Medium: 0.01 N hydrochloric acid; 900 mL.
Apparatus 1: 100 rpm.
Time: 20 minutes.
Standard solution Prepare a solution of USP Flurazepam Hydrochloride RS having an accurately known concentration similar to the concentration of the solution under test. Pipet 5 mL of this solution to a 10-mL volumetric flask, and dilute with 1% ammonium acetate to volume.
Test solution Pipet 5 mL of a filtered portion of the solution under test into a 10-mL volumetric flask, and dilute with 1% ammonium acetate to volume.
Procedure Determine the amount of C21H23ClFN3O·2HCl dissolved, using the Chromatographic system as set forth in the Related compounds test under Flurazepam Hydrochloride.
Tolerances Not less than 75% (Q) of the labeled amount of C21H23ClFN3O·2HCl is dissolved in 20 minutes.
Uniformity of dosage units 905: meet the requirements.
Mobile phase , System suitability solution, and Chromatographic systemPrepare as directed for Related compounds under Flurazepam Hydrochloride.
Standard preparation Dissolve an accurately weighed quantity of USP Flurazepam Hydrochloride RS in methanol, and dilute quantitatively, and stepwise if necessary, with Mobile phase to obtain a solution having a known concentration of about 0.15 mg per mL. Prepare fresh daily.
Assay preparation [notePrepare fresh daily.] Weigh and mix the contents of not fewer than 20 Capsules. Transfer an accurately weighed portion of the Capsule contents, equivalent to about 30 mg of flurazepam hydrochloride, to a 200-mL volumetric flask. Add 40 mL of methanol, and shake by mechanical means for 10 minutes. Add 10 mL of 1% ammonium acetate, and shake by mechanical means for 5 minutes. Dilute with Mobile phase to volume, mix and sonicate for 2 minutes, and filter.
Procedure Separately inject equal volumes (about 20 µL) of the Standard preparation and the Assay preparation into the chromatograph, record the chromatograms, and measure the responses for the major peaks. Calculate the quantity, in mg, of flurazepam hydrochloride (C21H23ClFN3O·2HCl) in the portion of Capsules taken by the formula:
200C(rU / rS)in which C is the concentration, in mg per mL, of USP Flurazepam Hydrochloride RS in the Standard preparation; and rU and rS are the peak responses obtained from the Assay preparation and the Standard preparation, respectively.
Auxiliary Information Please check for your question in the FAQs before contacting USP.Chromatographic Column
USP32NF27 Page 2429
Chromatographic columns text is not derived from, and not part of, USP 32 or NF 27.