Diazepam Tablets
» Diazepam Tablets contain not less than 90.0 percent and not more than 110.0 percent of the labeled amount of diazepam (C16H13ClN2O).
Packaging and storage— Preserve in tight, light-resistant containers.
Identification—
A: The retention time of the major peak in the chromatogram of the Assay preparation corresponds to that of the Standard preparation, as obtained in the Assay.
B: Accurately weigh an amount of Tablet mass, equivalent to 10 mg of diazepam, place in a 50-mL centrifuge tube, and add 2 mL of acetone. Place the centrifuge tube in an ultrasonic bath for 5 minutes, and centrifuge. Using 100 µL of the supernatant as the test solution, 100 µL of a solution of USP Diazepam RS in acetone containing 5 mg per mL as the Standard solution, and a solvent system consisting of equal volumes of ethyl acetate and n-heptane, proceed as directed in Identification test B under Diazepam. The specified result is observed.
Dissolution 711
Medium: 0.1 N hydrochloric acid; 900 mL.
Apparatus 1: 100 rpm.
Time: 30 minutes.
Procedure— Determine the amount of C16H13ClN2O dissolved by employing UV absorption at a wavelength of about 242 nm on filtered portions of the solution under test, suitably diluted with Dissolution Medium, if necessary, in comparison with a Standard solution having a known concentration of USP Diazepam RS in the same Medium.
Tolerances— Not less than 85% (Q) of the labeled amount of C16H13ClN2O is dissolved in 30 minutes.
Uniformity of dosage units 905: meet the requirements.
Assay—
Mobile phase, System suitability solution, Standard preparation, and Chromatographic system— Prepare as directed in the Assay under Diazepam.
Assay preparation— Weigh and finely powder not less than 20 Tablets. Transfer an accurately weighed portion of the powder, equivalent to about 10 mg of diazepam, to a 100-mL volumetric flask. Add about 50 mL of methanol, sonicate for 5 minutes, shake by mechanical means for 5 minutes, dilute with methanol to volume, mix, and filter, discarding the first few mL of the filtrate.
Procedure— Proceed as directed for Procedure in the Assay under Diazepam. Calculate the quantity, in mg, of diazepam (C16H13ClN2O) in the portion of Tablets taken by the formula:
100C(rU / rS)
in which C is the concentration, in mg per mL, of USP Diazepam RS in the Standard preparation, and rU and rS are the peak responses obtained from the Assay preparation and the Standard preparation, respectively.
Auxiliary Information— Please check for your question in the FAQs before contacting USP.
Topic/Question Contact Expert Committee
Monograph Ravi Ravichandran, Ph.D.
Senior Scientist
1-301-816-8330
(MDPP05) Monograph Development-Psychiatrics and Psychoactives
Reference Standards Lili Wang, Technical Services Scientist
1-301-816-8129
RSTech@usp.org
711 Margareth R.C. Marques, Ph.D.
Senior Scientist
1-301-816-8106
(BPC05) Biopharmaceutics05
USP32–NF27 Page 2116
Chromatographic Column—
Chromatographic columns text is not derived from, and not part of, USP 32 or NF 27.