Chromic Chloride Injection
» Chromic Chloride Injection is a sterile solution of Chromic Chloride in Water for Injection. It contains not less than 90.0 percent and not more than 110.0 percent of the labeled amount of chromium (Cr).
Packaging and storage
Preserve in single-dose or multiple-dose containers, preferably of Type I or Type II glass.
Labeling
Label the Injection to indicate that it is to be diluted to the appropriate strength with Sterile Water for Injection or other suitable fluid prior to administration.
Identification
The Assay preparation, prepared as directed in the Assay, exhibits an absorption maximum at about 360 nm when tested as directed for Procedure in the Assay.
Bacterial endotoxins 85
It contains not more than 16.70 USP Endotoxin Units per µg of chromium.
pH 791:
between 1.5 and 2.5.
Other requirements
It meets the requirements under Injections 1.
Assay
Sodium chloride solution
Dissolve 54 g of sodium chloride in water, dilute with water to 2000 mL, and mix.
Chromium stock solution
Transfer 2.829 g of potassium dichromate, accurately weighed, to a 1000-mL volumetric flask, dissolve in water, dilute with water to volume, and mix. This solution contains 1000 µg of chromium per mL. Store in a polyethylene bottle.
Standard preparations
Pipet 10 mL of the Chromium stock solution into a 1000-mL volumetric flask, dilute with water to volume, and mix. Transfer 10.0 mL and 20.0 mL, respectively, of this stock solution to separate 100-mL volumetric flasks, and transfer 15.0 mL and 20.0 mL, respectively, of the stock solution to separate 50-mL volumetric flasks. Add 20 mL of Sodium chloride solution to each 100-mL volumetric flask, and 10 mL of Sodium chloride solution to each 50-mL volumetric flask, dilute the contents of each flask with water to volume, and mix. These Standard preparations contain, respectively, 1.0, 2.0, 3.0, and 4.0 µg of chromium per mL.
Assay preparation
Transfer an accurately measured volume of Injection, equivalent to about 60 µg of chromium, to a 25-mL volumetric flask. From the labeled amount of sodium chloride, if any, in the Injection, calculate the amount, in mg, of sodium chloride in the volume of Injection taken, and add sufficient Sodium chloride solution to bring the total sodium chloride content of the flask to 135 mg. Dilute with water to volume, and mix.
Procedure
Concomitantly determine the absorbances of the Standard preparations and the Assay preparation at the chromium emission line of 357.9 nm, with a suitable atomic absorption spectrophotometer (see Spectrophotometry and Light-Scattering 851) equipped with a chromium hollow-cathode lamp and an airacetylene flame, using a 1:5 dilution of the Sodium chloride solution as the blank. Plot the absorbances of the Standard preparations versus concentration, in µg per mL, of chromium, and draw the straight line best fitting the four plotted points. From the graph so obtained, determine the concentration, in µg per mL, of chromium in the Assay preparation. Calculate the quantity, in µg, of chromium in each mL of the Injection taken by the formula:
25C/V
in which C is the concentration, in µg per mL, of chromium in the Assay preparation, and V is the volume, in mL, of Injection taken.
Auxiliary Information
Please check for your question in the FAQs before contacting USP.
USP32NF27 Page 1926
|