Ferrous Gluconate Tablets

Ferrous Gluconate Tablets contain Ferrous Gluconate. They are coated.

The tablets comply with the requirements stated under Tablets and with the following requirements.

90.0  to 105.0% of the stated amount.

A.  Shake a quantity of the powdered tablets containing 0.5  g of ferrous gluconate with 10  ml of 2m hydrochloric acid, filter and add to the filtrate 1  ml of barium chloride solution. An opalescence may be produced but no precipitate is produced.

B.  The powdered tablets yield reaction A characteristic of iron salts, Appendix VI.

Dissolve a quantity of the powder prepared for the Assay containing 5  g of ferrous gluconate as completely as possible without heating in a mixture of 100  ml of freshly boiled and cooled water and 10  ml of hydrochloric acid and add 3  g of potassium iodide. Close the vessel, allow to stand in the dark for 5  minutes and titrate the liberated iodine with 0.1m sodium thiosulphate VS using starch mucilage as indicator. Repeat the operation without the powder. The difference between the titrations represents the amount of iodine liberated by the ferric iron. Not more than 11.2  ml of 0.1m sodium thiosulphate VS is required.

Weigh and powder 20  tablets. Dissolve a quantity of the powder containing 1  g of ferrous gluconate as completely as possible in a mixture of 30  ml of water and 20  ml of 1m sulphuric acid and titrate with 0.1m ammonium cerium(iv)sulphate VS using ferroin solution as indicator. Each ml of 0.1m ammonium cerium(iv) sulphate VS is equivalent to 5.585  mg of Fe(ii).

The quantity of active ingredient is stated both as the amount of ferrous gluconate and in terms of the equivalent amount of ferrous iron.