Thiamine Hydrochloride Injection
» Thiamine Hydrochloride Injection is a sterile solution of Thiamine Hydrochloride in Water for Injection. It contains not less than 90.0 percent and not more than 110.0 percent of the labeled amount of thiamine hydrochloride (C12H17ClN4OS·HCl).
Packaging and storage
Preserve in single-dose or multiple-dose containers, preferably of Type I glass, protected from light.
Identification
A:
It yields a white precipitate with mercuric chloride TS, and a red-brown precipitate with iodine TS. It also yields a precipitate with mercuric-potassium iodide TS, and with trinitrophenol TS.
B:
Dilute a portion of Injection with water to a concentration of about 10 mg of thiamine hydrochloride per mL. To 0.5 mL of this solution add 5 mL of 0.5 N sodium hydroxide, then add 0.5 mL of potassium ferricyanide TS and 5 mL of isobutyl alcohol, shake the mixture vigorously for 2 minutes, and allow the liquid layers to separate: when illuminated from above by a vertical beam of UV light and viewed at a right angle to this beam, the air-liquid meniscus shows a vivid blue fluorescence, which disappears when the mixture is slightly acidified, but reappears when it is again made alkaline.
C:
It responds to the tests for Chloride 191.
Bacterial endotoxins 85
It contains not more than 3.5 USP Endotoxin Units per mg of thiamine hydrochloride.
pH 791:
between 2.5 and 4.5.
Other requirements
It meets the requirements under Injections 1.
Assay
Mobile phase, Internal standard solution, Standard preparation, and Chromatographic system
Prepare as directed in the Assay under Thiamine Hydrochloride Oral Solution.
Assay preparation
Quantitatively dilute an accurately measured volume of Injection with Mobile phase to obtain a solution containing about 500 µg of thiamine hydrochloride per mL. Pipet 10 mL of the resulting solution and 10 mL of Internal standard solution into a 100-mL volumetric flask, dilute with Mobile phase to volume, and mix.
Procedure
Proceed as directed for Procedure in the Assay under Thiamine Hydrochloride Oral Solution. Calculate the quantity, in mg, of thiamine hydrochloride (C12H17ClN4OS·HCl) in each mL of the Injection taken by the formula:
C(L/D)(RU / RS)
in which C is the concentration, in mg per mL, of USP Thiamine Hydrochloride RS in the Standard preparation; L is the labeled quantity, in mg per mL, of thiamine hydrochloride in the Injection; D is the concentration, in mg per mL, of thisamine hydrochloride in the Assay preparation on the basis of the labeled quantity and the extent of dilution; and RU and RS are the ratios of the peak responses of thiamine to methylparaben obtained from the Assay preparation and the Standard preparation, respectively.
Auxiliary Information
Please check for your question in the FAQs before contacting USP.
Chromatographic Column
USP32NF27 Page 3718
Pharmacopeial Forum: Volume No. 28(2) Page 380
Chromatographic columns text is not derived from, and not part of, USP 32 or NF 27.
|