Doxepin Hydrochloride Capsules
» Doxepin Hydrochloride Capsules contain not less than 90.0 percent and not more than 110.0 percent of the labeled amount of doxepin (C19H21NO).
Packaging and storage
Preserve in well-closed containers.
Identification
The retention times of the major peaks for (E)- and (Z)-isomers in the chromatogram of the Assay preparation correspond to those in the chromatogram of the Standard preparation, as obtained in the Assay.
Dissolution 711
Medium:
water; 900 mL.
Apparatus 1:
50 rpm.
Time:
30 minutes.
Procedure
Determine the amount of C19H21NO dissolved from UV absorbances at the wavelength of maximum absorbance at about 292 nm on filtered portions of the solution under test, suitably diluted with Medium, if necessary, in comparison with a Standard solution having a known concentration of USP Doxepin Hydrochloride RS in the same Medium.
Tolerances
Not less than 80% (Q) of the labeled amount of C19H21NO is dissolved in 30 minutes.
Uniformity of dosage units 905:
meet the requirements, the following procedure being used where the test for Content Uniformity is required.
Diluting solution
Prepare a mixture containing 500 mL of methanol and 500 mL of 0.05 M monobasic sodium phosphate, and filter. Adjust with 2 N sodium hydroxide to a pH of 6.7.
Standard preparation
Transfer 20 mg of USP Doxepin Hydrochloride RS, accurately weighed, to a 200-mL volumetric flask, dissolve in and dilute with Diluting solution to volume, and filter.
Test preparation
Transfer the contents of 1 Capsule into an appropriate volumetric flask, add Diluting solution to about 80% of the volume of the flask, and shake the flask by mechanical means for about 30 minutes. Dilute with Diluting solution to volume. Make further dilutions, if necessary, to obtain a solution having a known concentration of 0.1 mg per mL of doxepin hydrochloride. Individually test 9 more Capsules using the above procedure.
Procedure
Determine the amount of active ingredient in each unit of the Test preparation from UV absorbances at the wavelength of maximum absorbance at about 292 nm using 0.5-cm cells in comparison with the Standard preparation.
Water, Method I 921:
not more than 9.0%, determined on the contents of 1 Capsule.
Assay
Mobile phase, Standard preparation, and Chromatographic system
Proceed as directed in the Assay under Doxepin Hydrochloride.
Assay preparation
Remove, as completely as possible, the contents of not fewer than 20 Capsules. Weigh the contents and determine the average weight per Capsule. Mix the combined contents, and transfer an accurately weighed quantity of the powder, equivalent to about 50 mg of doxepin hydrochloride, to a 100-mL volumetric flask. Add about 70 mL of Mobile phase, and shake by mechanical means for 30 minutes. Dilute with Mobile phase to volume, mix, and filter. Pipet 10.0 mL of this solution into a 50-mL volumetric flask, dilute with Mobile phase to volume, and mix.
Procedure
Proceed as directed for Procedure in the Assay under Doxepin Hydrochloride. Calculate the quantity, in mg, of C19H21NO·HCl in the portion of Capsules taken by the formula:
0.5C[(rU(Z) + rU(E)) / (rS(Z) + rS(E))]
in which the terms are as defined therein.
Auxiliary Information
Please check for your question in the FAQs before contacting USP.
Chromatographic Column
USP32NF27 Page 2208
Pharmacopeial Forum: Volume No. 30(6) Page 1987
Chromatographic columns text is not derived from, and not part of, USP 32 or NF 27.
|