Ceftazidime
Pyridinium, 1-[[7-[[(2-amino-4-thiazolyl)[(1-carboxy-1-methylethoxy)imino]acetyl]amino]-2-carboxy-8-oxo-5-thia-1-azabicyclo[4.2.0]oct-2-en-3-yl]methyl]-, hydroxide, inner salt, pentahydrate, [6R[6,7(Z)]]-. 1-[[(6R,7R)-7-[2-(2-Amino-4-thiazolyl)glyoxylamido]-2-carboxy-8-oxo-5-thia-1-azabicyclo[4.2.0]oct-2-en3-yl]methyl]pyridinium hydroxide, inner salt, 72-(Z)-[O(1-carboxy-1-methylethyl)oxime], pentahydrate [78439-06-2]. Anhydrous 546.59 » Ceftazidime contains not less than 95.0 percent and not more than 102.0 percent of C22H22N6O7S2, calculated on the dried basis.
Packaging and storage
Preserve in tight containers.
Labeling
Where it is intended for use in preparing injectable dosage forms, the label states that it is sterile or must be subjected to further processing during the preparation of injectable or other sterile dosage forms.
USP Reference standards 11
USP Ceftazidime Delta-3-Isomer RS. USP Ceftazidime Pentahydrate RS. USP Endotoxin RS.
Identification
The chromatogram of the Assay preparation obtained as directed in the Assay exhibits a major peak for ceftazidime, the retention time of which corresponds to that exhibited in the chromatogram of the Standard preparation, as obtained in the Assay.
Crystallinity 695:
meets the requirements.
Sterility 71
Where the label states that it is sterile, it meets the requirements when tested as directed for Membrane Filtration under Test for Sterility of the Product to be Examined, except to use Fluid A to each 1000 mL of which has been added 10 g of sodium bicarbonate before sterilization.
pH 791:
between 3.0 and 4.0, in a solution containing 5 mg per mL.
Loss on drying 731
Dry about 300 mg, accurately weighed, in vacuum at a pressure not exceeding 5 mm of mercury at 60 for 3 hours: it loses between 13.0% and 15.0% of its weight.
Other requirements
Where the label states that Ceftazidime is sterile or that it must be subjected to further processing during the preparation of injectable or other sterile dosage forms, it meets the requirements for Bacterial endotoxins under Ceftazidime for Injection.
Assay
pH 7 Buffer
Dissolve 42.59 g of anhydrous dibasic sodium phosphate and 27.22 g of monobasic potassium phosphate in water to make 1000 mL of solution.
Mobile phase
Mix 40 mL of acetonitrile and 200 mL of pH 7 Buffer, and dilute with water to obtain 2000 mL of solution. Filter, using a filter having a porosity of 1 µm or finer, and degas. Make adjustments if necessary (see System Suitability under Chromatography 621).
Standard preparation
Transfer about 29 mg of USP Ceftazidime Pentahydrate RS, accurately weighed, to a 25-mL volumetric flask containing 2.5 mL of pH 7 Buffer, and shake until dissolved. Dilute with water to volume, and mix. [noteProtect this solution from light.] Immediately prior to chromatography, transfer 5.0 mL of this stock solution to a 50-mL volumetric flask, dilute with water to volume, and mix. This solution contains about 100 µg of ceftazidime (C22H22N6O7S2) per mL.
Assay preparation
Transfer about 115 mg of Ceftazidime, accurately weighed, to a 100-mL volumetric flask containing 10.0 mL of pH 7 Buffer, and shake until dissolved. Dilute with water to volume, and mix. [noteProtect this solution from light.] Immediately prior to chromatography, transfer 5.0 mL of this solution to a 50-mL volumetric flask, dilute with water to volume, and mix.
Resolution solution
Prepare a solution of USP Ceftazidime, Delta-3-Isomer RS in pH 7 Buffer containing about 0.1 mg per mL. Immediately prior to chromatography, mix 1 mL of this solution with 8 mL of water and 1 mL of the stock solution used to prepare the Standard preparation.
Chromatographic system
(see Chromatography 621)The liquid chromatograph is equipped with a 254-nm detector and a 4.6-mm × 15-cm column that contains 5-µm packing L1. The flow rate is about 2 mL per minute. Chromatograph the Resolution solution, and record the peak responses as directed for Procedure: the resolution, R, between ceftazidime and ceftazidime, delta-3-isomer is not less than 2.0. Chromatograph the Standard preparation, and record the responses as directed for Procedure: the tailing factor for the analyte peak is not less than 0.75 and not more than 1.5, and the relative standard deviation for replicate injections is not more than 1.0%.
Procedure
Separately inject equal volumes (about 20 µL) of the Standard preparation and the Assay preparation into the chromatograph, record the chromatograms, and measure the responses for the major peaks. Calculate the quantity, in mg, of C22H22N6O7S2 in the portion of Ceftazidime taken by the formula:
C(rU / rS)
in which C is the concentration, in µg per mL, of ceftazidime (C22H22N6O7S2) in the Standard preparation; and rU and rS are the peak responses obtained from the Assay preparation and the Standard preparation, respectively.
Auxiliary Information
Please check for your question in the FAQs before contacting USP.
Chromatographic Column
USP32NF27 Page 1857
Pharmacopeial Forum: Volume No. 32(1) Page 67
Chromatographic columns text is not derived from, and not part of, USP 32 or NF 27.
|