Metolazone Oral Suspension
» Metolazone Oral Suspension contains not less than 90.0 percent and not more than 110.0 percent of the labeled amount of metolazone (C16H16ClN3O3S). Prepare Metolazone Oral Suspension 1 mg per mL as follows (see Pharmaceutical CompoundingNonsterile Preparations 795):
If using Tablets, place the Metolazone Tablets in a suitable mortar, and comminute to a fine powder, or add Metolazone powder to the mortar. Add about 20 mL of the Vehicle, and mix to a uniform paste. Add the Vehicle in small portions, and transfer the contents of the mortar, stepwise and quantitatively, to a calibrated bottle. Add sufficient Vehicle in portions to rinse the mortar, add sufficient Vehicle to final volume, and mix well.
Packaging and storage
Preserve in tight, light-resistant containers. Store at controlled room temperature, or in a cold place.
Labeling
Label it to state that it is to be well shaken, and to state the beyond-use date.
pH 791:
between 3.6 and 4.6.
Beyond-use date:
60 days after the day on which it was compounded.
Assay
Mobile phase
Prepare a suitable filtered and degassed mixture of 700 mL of methanol, 300 mL of 1.5 g ammonium acetate, and 1 mL of diisopropylamine. Make adjustments if necessary (see System Suitability under Chromatography 621).
Standard preparation
Dissolve USP Metolazone RS in water to obtain a solution having a known concentration of 1.0 µg per mL.
Assay preparation
Agitate the container of Oral Suspension for 30 minutes on a rotating mixer, remove a 5-mL sample, and store in a clear glass vial at 70 until analyzed. At the time of analysis, remove the sample from the freezer, allow it to reach room temperature, and mix with a vortex mixer for 30 seconds. Pipet 1.0 mL of the sample into a 1000-mL volumetric flask, and dilute with Mobile phase to volume.
Chromatographic system (see Chromatography 621)
The liquid chromatograph is equipped with a 254-nm detector and a 4.6-mm × 20-cm analytical column that contains 5-µm packing L3. The flow rate is about 1.0 mL per minute. Chromatograph the Standard preparation, and record the peak responses as directed for Procedure: the retention time for metolazone is about 6.0 minutes, and the relative standard deviation for replicate injections is not more than 2.2%.
Procedure
Separately inject equal volumes (about 20 µL) of the Standard preparation and the Assay preparation into the chromatograph, record the chromatograms, and measure the responses for the major peaks. Calculate the quantity, in mg, of metolazone (C16H16ClN3O3S) in the volume of Oral Suspension taken by the formula:
1000(C/V)(rU / rS)
in which C is the concentration, in µg per mL, of USP Metolazone RS in the Standard preparation; V is the volume, in mL, of Oral Suspension taken; and rU and rS are the peak responses obtained from the Assay preparation and the Standard preparation, respectively.
Auxiliary Information
Please check for your question in the FAQs before contacting USP.
USP32NF27 Page 2962
Pharmacopeial Forum: Volume No. 32(1) Page 119
|